Saturday Sawdust Factory

Cutting is going well.

The plexi has been cut and sanded:

• First the rough cut with the circular saw
  
  
• The three sheets stacked with one of the tops as a template. Turns out the secret is double sided tape.
  
• I trimmed the edges with a router using a tracing bit and then did a little sanding. Later the edges will be flame polished.
  

Two new bases have been cut to replace the ones that look like they were done by a monkey... or me.


All of the angles have been cut on the back end of the sides. Just need to cut length and adjust height for the different tops.

There is a good chance I'll be on to hinges and legs tomorrow!